Ottoman divan
Ottoman divan instructions
Use these steps only when your supplied fittings match the list below. Assembly is easier with two people.
Before you start
Unpack and check all parts on a protected floor. Keep the instructions supplied with your exact model to hand. If parts are missing or the fittings differ, contact us before continuing.
Tools required
- Spanner
- Screwdriver
- Drill
- Two people are recommended
Fixings supplied
- 4 white washer bolts for the headboard
- 8 chrome feet for the bases
- 2 metal U-clips to join the bases
- 1 bolt, 2 washers and 1 nut for the ottoman lid
1Fit the chrome feet
- Remove the bases from the packaging and open one base. The fixings bag should be inside.
- Turn both bases upside down.
- Remove the 8 chrome feet from the wrapping and push them firmly into the metal inserts on the bottom of the bases.
- If needed, use the palm of your hand to push the feet fully into place.
2Join the bases together
- Place the bases back on their feet.
- You will have one left piece and one right piece, marked on the packaging.
- Position both bases together.
- Use the 2 metal U-clips to secure the bases, with one at the foot end and one at the back.
- Push the U-clips firmly into place so the bases do not move.
- For a side-lift bed, either base can go on either side.
3Attach the headboard
- Remove the headboard from its packaging.
- Position it behind the base if it is a floor-standing headboard.
- Align the headboard with the pre-fitted T-nuts on the base.
- Insert the 4 white washer bolts through the headboard into the T-nuts.
- Tighten all 4 bolts securely.
4Attach the ottoman lids
- Open both lids.
- Each base has 2 ottoman jacks, making 4 in total.
- The screw will already be in the hole. Unscrew it first.
- Use a screwdriver to line up the hole on the ottoman jack with the hole on the lid. You may need to insert the screwdriver to open up the hole.
- Insert the screw and tighten it with a drill.
- Repeat for all 4 jacks, 2 on each base.
5Secure the lid bolt
- Take the bolt, washers and nut.
- Remove one washer and the nut.
- Insert the bolt through the hole in the ottoman lid.
- Add the remaining washer and nut on the other side.
- Tighten securely.
Final check
Make sure all fixings are secure before using the bed. If you are unsure about any step, contact A2Z Beds before continuing.